Thingiverse
Simple anemometer
von deniboj
16
Downloads
7
Likes
0
Makes
I needed an anemometer to see when I can fly my RC models. Basically when it turns even very slowly- I wouldn't fly with smaller models.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
