Thingiverse
Simple anemometer
door deniboj
16
Downloads
7
Likes
0
Makes
I needed an anemometer to see when I can fly my RC models. Basically when it turns even very slowly- I wouldn't fly with smaller models.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
