Thingiverse
Simple anemometer
by deniboj
16
Downloads
7
Likes
0
Makes
I needed an anemometer to see when I can fly my RC models. Basically when it turns even very slowly- I wouldn't fly with smaller models.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
The last one I printed was from ABS and it lasted 2 years on the sun (35C) and in the cold (-20C) ... Now I'm trying PETG
This design uses a 608 bearing and a 10mm rod for the anemometer itself.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
