Thingiverse
Support Spindle
von stjaimy
5
Downloads
14
Likes
0
Makes
The base for making your own Support spindle. All you need to add is a 10mm diameter dowl (or in my case a paintbrush)
I recommend using a 50% or higher infill. I used 50% which worked fine, but I would like it to be a little heavier so a higher percentage is recommended.
I recommend using a 50% or higher infill. I used 50% which worked fine, but I would like it to be a little heavier so a higher percentage is recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
