Thingiverse
Support Test Stand
door JohnOCFII
5
Downloads
8
Likes
0
Makes
Two simple models to test different slicer support settings.
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
JohnOCFII publiceert ook op
39 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!