Thingiverse
Support Test Stand
by JohnOCFII
5
Downloads
8
Likes
0
Makes
Two simple models to test different slicer support settings.
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
JohnOCFII also publishes on
40 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!