Thingiverse
Support Test Stand
por JohnOCFII
5
Descargas
8
Likes
0
Makes
Two simple models to test different slicer support settings.
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
JohnOCFII también publica en
40 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!