Thingiverse
Support Test Stand
von JohnOCFII
5
Downloads
8
Likes
0
Makes
Two simple models to test different slicer support settings.
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
JohnOCFII veröffentlicht auch auf
39 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!