Thingiverse
Teal Drone Float
by TuckyIA
0
Downloads
2
Likes
0
Makes
Here is a float for your Teal drone.
Picture this: You are flying over a lake. Suddenly, your battery cuts out and the drone falls from the air into the deepest part of the lake. Normally, it would be R.I.P drone, but with this, it will float on the surface with a good chance of being repaired if the battery doesn't have any charge left to be short-circuited. Tada, you either saved tons of time contacting Teal about a warranty or spending hundreds more to buy a new drone. Also, this will protect the lake, too, as it won't get stuck with what is likely a non-biodegradable drone stuck at the bottom.
Not for use when there are large waves.
I claim no responsibility if something goes wrong and you cannot rescue the drone.
It is highly recommended that you use a better print quality printer than I did.
Have fun and fly on!
Picture this: You are flying over a lake. Suddenly, your battery cuts out and the drone falls from the air into the deepest part of the lake. Normally, it would be R.I.P drone, but with this, it will float on the surface with a good chance of being repaired if the battery doesn't have any charge left to be short-circuited. Tada, you either saved tons of time contacting Teal about a warranty or spending hundreds more to buy a new drone. Also, this will protect the lake, too, as it won't get stuck with what is likely a non-biodegradable drone stuck at the bottom.
Not for use when there are large waves.
I claim no responsibility if something goes wrong and you cannot rescue the drone.
It is highly recommended that you use a better print quality printer than I did.
Have fun and fly on!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!