Slicer Discord
Teal Drone Float – Modèle 3D imprimable de Thingiverse Thingiverse

Teal Drone Float

par TuckyIA
0 Téléchargements
2 Likes
0 Makes
Voir le modèle
Here is a float for your Teal drone.
Picture this: You are flying over a lake. Suddenly, your battery cuts out and the drone falls from the air into the deepest part of the lake. Normally, it would be R.I.P drone, but with this, it will float on the surface with a good chance of being repaired if the battery doesn't have any charge left to be short-circuited. Tada, you either saved tons of time contacting Teal about a warranty or spending hundreds more to buy a new drone. Also, this will protect the lake, too, as it won't get stuck with what is likely a non-biodegradable drone stuck at the bottom.
Not for use when there are large waves.
I claim no responsibility if something goes wrong and you cannot rescue the drone.
It is highly recommended that you use a better print quality printer than I did.
Have fun and fly on!
Source
Thingiverse
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection