Slicer Discord
Teal Drone Float – 3D-printbaar model van Thingiverse Thingiverse

Teal Drone Float

door TuckyIA
0 Downloads
2 Likes
0 Makes
Model downloaden
Here is a float for your Teal drone.
Picture this: You are flying over a lake. Suddenly, your battery cuts out and the drone falls from the air into the deepest part of the lake. Normally, it would be R.I.P drone, but with this, it will float on the surface with a good chance of being repaired if the battery doesn't have any charge left to be short-circuited. Tada, you either saved tons of time contacting Teal about a warranty or spending hundreds more to buy a new drone. Also, this will protect the lake, too, as it won't get stuck with what is likely a non-biodegradable drone stuck at the bottom.
Not for use when there are large waves.
I claim no responsibility if something goes wrong and you cannot rescue the drone.
It is highly recommended that you use a better print quality printer than I did.
Have fun and fly on!
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie