Thingiverse
USB Ecotower
por CreatorD
4
Descargas
3
Likes
0
Makes
A simple USB Type A holding tower using a minimal amount of plastic (and print time). There is a small amount of infill at the bottom of the tower.
The USB plug fit may be a bit loose/tight depending on your print settings and the particular USB device. The holes are *almost* the size of regular USB Type A plugs (+0.3 mm width, +0.1 mm height).
The USB plug fit may be a bit loose/tight depending on your print settings and the particular USB device. The holes are *almost* the size of regular USB Type A plugs (+0.3 mm width, +0.1 mm height).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
