Thingiverse
USB Ecotower
di CreatorD
4
Download
3
Likes
0
Makes
A simple USB Type A holding tower using a minimal amount of plastic (and print time). There is a small amount of infill at the bottom of the tower.
The USB plug fit may be a bit loose/tight depending on your print settings and the particular USB device. The holes are *almost* the size of regular USB Type A plugs (+0.3 mm width, +0.1 mm height).
The USB plug fit may be a bit loose/tight depending on your print settings and the particular USB device. The holes are *almost* the size of regular USB Type A plugs (+0.3 mm width, +0.1 mm height).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
