Thingiverse
Warhammer Stackable Display cap for set
13
Downloads
4
Likes
0
Makes
This is a cap for the 25,28,32 and 40 mm display trays I made. After I put it together, it needed something on the top to make it look right on a shelf.
It's 150mm x 150mm x25.5 mm tal. It will take about 8-10 hours to print depending on how much infill you use. I used 30%.
It will print without supports except for the 4 holes on the bottom. The top does not need anything to print correctly.
It's 150mm x 150mm x25.5 mm tal. It will take about 8-10 hours to print depending on how much infill you use. I used 30%.
It will print without supports except for the 4 holes on the bottom. The top does not need anything to print correctly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
