Thingiverse
Warhammer Stackable Display cap for set
13
Downloads
4
Likes
0
Makes
This is a cap for the 25,28,32 and 40 mm display trays I made. After I put it together, it needed something on the top to make it look right on a shelf.
It's 150mm x 150mm x25.5 mm tal. It will take about 8-10 hours to print depending on how much infill you use. I used 30%.
It will print without supports except for the 4 holes on the bottom. The top does not need anything to print correctly.
It's 150mm x 150mm x25.5 mm tal. It will take about 8-10 hours to print depending on how much infill you use. I used 30%.
It will print without supports except for the 4 holes on the bottom. The top does not need anything to print correctly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
