Thingiverse
Wire Box
by Micklen
4
Downloads
1
Likes
0
Makes
Simple Wire Management Box.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
Micklen also publishes on
7 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
