Thingiverse
Wire Box
von Micklen
4
Downloads
1
Likes
0
Makes
Simple Wire Management Box.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
Micklen veröffentlicht auch auf
7 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
