Thingiverse
Wire Box
door Micklen
4
Downloads
1
Likes
0
Makes
Simple Wire Management Box.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
I use these any place I have extra wire that I want to hide.
Can be attached to Extrusion rails with a T Nut and Bolt. Or can be bolted/screwed/zip-tied/velcro'd on to any number of locations.
Lid snaps on. Depending on the amount of stuff you pack in the box, may want to loop a velcro strap or similar around it. (As shown in pic.)
Can be printed from any non-flexible material as desired. Mostly I use PLA unless it will be mounted in a heated area.
Micklen publiceert ook op
7 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
