Thingiverse
Robotics
Zum Modell
Basic L298n Mount
13
Downloads
16
Likes
0
Makes
Basic Mount for L298n H-Bridge Motor Driver.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
