Thingiverse
Robotics
Ver Modelo
Basic L298n Mount
13
Descargas
16
Likes
0
Makes
Basic Mount for L298n H-Bridge Motor Driver.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
