Thingiverse
Robotics
Model downloaden
Basic L298n Mount
13
Downloads
16
Likes
0
Makes
Basic Mount for L298n H-Bridge Motor Driver.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
Use M3 Spacers (+Screws +Nuts) to Mount Driver (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep). They are diagonally opposite so you can put another one very close.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
