Thingiverse
Basic Shower head
von phivinhngoc
9
Downloads
12
Likes
1
Makes
FIXED
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
