Thingiverse
Basic Shower head
por phivinhngoc
9
Descargas
12
Likes
1
Makes
FIXED
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
