Thingiverse
Basic Shower head
by phivinhngoc
9
Downloads
12
Likes
1
Makes
FIXED
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
