Thingiverse
Basic Shower head
door phivinhngoc
9
Downloads
12
Likes
1
Makes
FIXED
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
