Slicer Discord
fog light switchbox – 3D printable model from MakerOnline MakerOnline
fog light switchbox – Bild 1 fog light switchbox – Bild 2
Hobby&DIY

fog light switchbox

2 Downloads
3 Likes
0 Makes
Go to Model
pt cruisers with foglights have an issue where the switch drains power even when everything is turned off. Chrysler sucks and their solution is to either buy a $200 replacement light controller (plus install), or remove the fuse that runs the foglight circuit. Forget that, instead I'm adding a fuse extender and a switch so I can turn them on at will. If this works well I'll probably bypass the the switch on the steering column and run entirely off of this, but for now there will be two switches in series. Switches used - https://www.aliexpress.com/item/1005007630181105.html Fuse extender - https://www.aliexpress.com/item/1005005320045496.html Category: Automotive
Category
Hobby&DIY
Source
MakerOnline
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

unhooked also publishes on

142 additional models across 2 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection