Slicer Discord
fog light switchbox – Modelo 3D imprimible de MakerOnline MakerOnline
fog light switchbox – Bild 1 fog light switchbox – Bild 2
Hobby&DIY

fog light switchbox

2 Descargas
3 Likes
0 Makes
Ver Modelo
pt cruisers with foglights have an issue where the switch drains power even when everything is turned off. Chrysler sucks and their solution is to either buy a $200 replacement light controller (plus install), or remove the fuse that runs the foglight circuit. Forget that, instead I'm adding a fuse extender and a switch so I can turn them on at will. If this works well I'll probably bypass the the switch on the steering column and run entirely off of this, but for now there will be two switches in series. Switches used - https://www.aliexpress.com/item/1005007630181105.html Fuse extender - https://www.aliexpress.com/item/1005005320045496.html Category: Automotive
Categoría
Hobby&DIY
Fuente
MakerOnline
Publicado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

unhooked también publica en

142 modelos adicionales en 2 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección