Slicer Discord
fog light switchbox – 3D-printbaar model van MakerOnline MakerOnline
fog light switchbox – Bild 1 fog light switchbox – Bild 2
Hobby&DIY

fog light switchbox

2 Downloads
3 Likes
0 Makes
Model downloaden
pt cruisers with foglights have an issue where the switch drains power even when everything is turned off. Chrysler sucks and their solution is to either buy a $200 replacement light controller (plus install), or remove the fuse that runs the foglight circuit. Forget that, instead I'm adding a fuse extender and a switch so I can turn them on at will. If this works well I'll probably bypass the the switch on the steering column and run entirely off of this, but for now there will be two switches in series. Switches used - https://www.aliexpress.com/item/1005007630181105.html Fuse extender - https://www.aliexpress.com/item/1005005320045496.html Category: Automotive
Categorie
Hobby&DIY
Bron
MakerOnline
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

unhooked publiceert ook op

142 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie