Slicer Discord
fog light switchbox – Modèle 3D imprimable de MakerOnline MakerOnline
fog light switchbox – Bild 1 fog light switchbox – Bild 2
Hobby&DIY

fog light switchbox

2 Téléchargements
3 Likes
0 Makes
Voir le modèle
pt cruisers with foglights have an issue where the switch drains power even when everything is turned off. Chrysler sucks and their solution is to either buy a $200 replacement light controller (plus install), or remove the fuse that runs the foglight circuit. Forget that, instead I'm adding a fuse extender and a switch so I can turn them on at will. If this works well I'll probably bypass the the switch on the steering column and run entirely off of this, but for now there will be two switches in series. Switches used - https://www.aliexpress.com/item/1005007630181105.html Fuse extender - https://www.aliexpress.com/item/1005005320045496.html Category: Automotive
Catégorie
Hobby&DIY
Source
MakerOnline
Publié
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

unhooked publie également sur

142 modèles supplémentaires sur 2 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection