Thingiverse
Monkey Pod Camera Stand Link
von Mr_Dabrudda
34
Downloads
19
Likes
0
Makes
A redesign of the JOBY GorillaPOD flexi camera stand.
0.2 Layer
50% Infill
0.8 Wall Thickness
45-55mm/s print speed
Support Placement: Touching Buildplate
Support Pattern: Lines
Support Density: 10% Support Density
Build Plate Adhesion:
Brim @ 3mm
Ran the STL thru Netfabb to check for any errors.
0.2 Layer
50% Infill
0.8 Wall Thickness
45-55mm/s print speed
Support Placement: Touching Buildplate
Support Pattern: Lines
Support Density: 10% Support Density
Build Plate Adhesion:
Brim @ 3mm
Ran the STL thru Netfabb to check for any errors.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
