Slicer Discord
Nutating Disc Engine (functional demonstration) – 3D-Druckmodell von MakerWorld MakerWorld
Engineering

Nutating Disc Engine (functional demonstration)

31 Downloads
33 Likes
10 Makes
Zum Modell
A nutating disc engine is a type of positive displacement engine that uses a wobbling disc instead of pistons or rotors. The disc inside nutates - meaning that rather than rotating, the disc wobbles on it's rim like a coin as it dies after spinning on a table. This particular model, while really just a demonstration of the concept, will actually spin if you apply enough compressed air to one of the inlet ports. Unfortunately, it lacks any proper seals which would allow it to generate any real power. On the plus side, it is very easy to disassemble to see how it works inside. It's a little hard to figure out how this engine works until you see that 1) airflow is blocked between the inlet and the outlet by a stationary vane (that also keeps the disk from spinning) and that 2) the funky dog-leg shaft forces the conical part of the disc to seal against the top and bottom of the chamber creating isolated high pressure and low pressure air pockets. This pressure differential (from in
Kategorie
Engineering
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

LoboCNC veröffentlicht auch auf

313 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen