Slicer Discord
Nutating Disc Engine (functional demonstration) – 3D-printbaar model van MakerWorld MakerWorld
Engineering

Nutating Disc Engine (functional demonstration)

31 Downloads
33 Likes
10 Makes
Model downloaden
A nutating disc engine is a type of positive displacement engine that uses a wobbling disc instead of pistons or rotors. The disc inside nutates - meaning that rather than rotating, the disc wobbles on it's rim like a coin as it dies after spinning on a table. This particular model, while really just a demonstration of the concept, will actually spin if you apply enough compressed air to one of the inlet ports. Unfortunately, it lacks any proper seals which would allow it to generate any real power. On the plus side, it is very easy to disassemble to see how it works inside. It's a little hard to figure out how this engine works until you see that 1) airflow is blocked between the inlet and the outlet by a stationary vane (that also keeps the disk from spinning) and that 2) the funky dog-leg shaft forces the conical part of the disc to seal against the top and bottom of the chamber creating isolated high pressure and low pressure air pockets. This pressure differential (from in
Categorie
Engineering
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie