Slicer Discord
Nutating Disc Engine (functional demonstration) – Modèle 3D imprimable de MakerWorld MakerWorld
Engineering

Nutating Disc Engine (functional demonstration)

31 Téléchargements
33 Likes
10 Makes
Voir le modèle
A nutating disc engine is a type of positive displacement engine that uses a wobbling disc instead of pistons or rotors. The disc inside nutates - meaning that rather than rotating, the disc wobbles on it's rim like a coin as it dies after spinning on a table. This particular model, while really just a demonstration of the concept, will actually spin if you apply enough compressed air to one of the inlet ports. Unfortunately, it lacks any proper seals which would allow it to generate any real power. On the plus side, it is very easy to disassemble to see how it works inside. It's a little hard to figure out how this engine works until you see that 1) airflow is blocked between the inlet and the outlet by a stationary vane (that also keeps the disk from spinning) and that 2) the funky dog-leg shaft forces the conical part of the disc to seal against the top and bottom of the chamber creating isolated high pressure and low pressure air pockets. This pressure differential (from in
Catégorie
Engineering
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

LoboCNC publie également sur

313 modèles supplémentaires sur 1 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection