Slicer Discord
Nutating Disc Engine (functional demonstration) – Modello 3D stampabile da MakerWorld MakerWorld
Engineering

Nutating Disc Engine (functional demonstration)

31 Download
33 Likes
10 Makes
Vai al Modello
A nutating disc engine is a type of positive displacement engine that uses a wobbling disc instead of pistons or rotors. The disc inside nutates - meaning that rather than rotating, the disc wobbles on it's rim like a coin as it dies after spinning on a table. This particular model, while really just a demonstration of the concept, will actually spin if you apply enough compressed air to one of the inlet ports. Unfortunately, it lacks any proper seals which would allow it to generate any real power. On the plus side, it is very easy to disassemble to see how it works inside. It's a little hard to figure out how this engine works until you see that 1) airflow is blocked between the inlet and the outlet by a stationary vane (that also keeps the disk from spinning) and that 2) the funky dog-leg shaft forces the conical part of the disc to seal against the top and bottom of the chamber creating isolated high pressure and low pressure air pockets. This pressure differential (from in
Categoria
Engineering
Fonte
MakerWorld
Pubblicato
Aggiornato
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Software
Cura, PrusaSlicer o simile
Stesso designer, più piattaforme

LoboCNC pubblica anche su

313 modelli aggiuntivi su altre 1 piattaforme

Verificato dalla corrispondenza dei titoli dei modelli tra le piattaforme.
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione