Slicer Discord
PAXPACKER – 3D-Druckmodell von Thingiverse Thingiverse

PAXPACKER

145 Downloads
98 Likes
2 Makes
Zum Modell
OK, I admit I like weed and that's a good thing cause I'm Canadian !

So here's a little gadget I designed in order to pack the best and most dense weed pucks that fit straight into your PAX 2 or 3 herb vaporizer.

Just fill the receiver cup, and then push the weed down the funnel with your finger. Once the weed is in, just insert the pusher and then squeeze both parts with your hand (or push it on a hard surface (if you're a wimp). Apply pressure until the weed is fully compressed. Remove the end cap, insert end of the funnel in the PAX herb oven and give it one last push with the pusher, you'll hear a "clic" which means your PAX is locked and loaded for your next session.

The puck size is optimized to allow airflow around the weed puck for the best and most efficient puff ever.

Enjoy !
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Montrealer veröffentlicht auch auf

1 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen