Slicer Discord
PAXPACKER – 3D-printbaar model van Thingiverse Thingiverse

PAXPACKER

door Montrealer
145 Downloads
98 Likes
2 Makes
Model downloaden
OK, I admit I like weed and that's a good thing cause I'm Canadian !

So here's a little gadget I designed in order to pack the best and most dense weed pucks that fit straight into your PAX 2 or 3 herb vaporizer.

Just fill the receiver cup, and then push the weed down the funnel with your finger. Once the weed is in, just insert the pusher and then squeeze both parts with your hand (or push it on a hard surface (if you're a wimp). Apply pressure until the weed is fully compressed. Remove the end cap, insert end of the funnel in the PAX herb oven and give it one last push with the pusher, you'll hear a "clic" which means your PAX is locked and loaded for your next session.

The puck size is optimized to allow airflow around the weed puck for the best and most efficient puff ever.

Enjoy !
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Montrealer publiceert ook op

1 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie