Slicer Discord
PAXPACKER – Modello 3D stampabile da Thingiverse Thingiverse

PAXPACKER

145 Download
98 Likes
2 Makes
Vai al Modello
OK, I admit I like weed and that's a good thing cause I'm Canadian !

So here's a little gadget I designed in order to pack the best and most dense weed pucks that fit straight into your PAX 2 or 3 herb vaporizer.

Just fill the receiver cup, and then push the weed down the funnel with your finger. Once the weed is in, just insert the pusher and then squeeze both parts with your hand (or push it on a hard surface (if you're a wimp). Apply pressure until the weed is fully compressed. Remove the end cap, insert end of the funnel in the PAX herb oven and give it one last push with the pusher, you'll hear a "clic" which means your PAX is locked and loaded for your next session.

The puck size is optimized to allow airflow around the weed puck for the best and most efficient puff ever.

Enjoy !
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Software
Cura, PrusaSlicer o simile
Stesso designer, più piattaforme

Montrealer pubblica anche su

1 modelli aggiuntivi su altre 1 piattaforme

Verificato dalla corrispondenza dei titoli dei modelli tra le piattaforme.
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione