Slicer Discord
PAXPACKER – Modèle 3D imprimable de Thingiverse Thingiverse

PAXPACKER

145 Téléchargements
98 Likes
2 Makes
Voir le modèle
OK, I admit I like weed and that's a good thing cause I'm Canadian !

So here's a little gadget I designed in order to pack the best and most dense weed pucks that fit straight into your PAX 2 or 3 herb vaporizer.

Just fill the receiver cup, and then push the weed down the funnel with your finger. Once the weed is in, just insert the pusher and then squeeze both parts with your hand (or push it on a hard surface (if you're a wimp). Apply pressure until the weed is fully compressed. Remove the end cap, insert end of the funnel in the PAX herb oven and give it one last push with the pusher, you'll hear a "clic" which means your PAX is locked and loaded for your next session.

The puck size is optimized to allow airflow around the weed puck for the best and most efficient puff ever.

Enjoy !
Source
Thingiverse
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

Montrealer publie également sur

1 modèles supplémentaires sur 1 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection