Thingiverse
Thread holder (updated)
von Danimal91
7
Downloads
4
Likes
0
Makes
The print pictured was printed in PLA
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
Danimal91 veröffentlicht auch auf
15 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
