Thingiverse
Thread holder (updated)
by Danimal91
7
Downloads
4
Likes
0
Makes
The print pictured was printed in PLA
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
Danimal91 also publishes on
15 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
