Thingiverse
Thread holder (updated)
door Danimal91
7
Downloads
4
Likes
0
Makes
The print pictured was printed in PLA
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
No supports are needed, print with the front, facing down on the build plate.
Use double-sided tape to attach it to the table
To create the screw holder on the back I super glued and m3 screw in from underneath and threaded on a bolt. I used a bolt handle found here:
https://www.thingiverse.com/thing:5532943
to make removal easier.
Danimal91 publiceert ook op
15 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
