Thingiverse
Wide leaf rake
von Snabel_a
4
Downloads
10
Likes
0
Makes
This is a 60cm wide rake for a 28mm wooden handle.
Printed and tested and it works very well.
Print the pins in PETG for flexibility. The rake body can be PLA. No support is needed. Push a piece of steel wire through the hole in the body and pins to hold the pins in place. 33 pins are required.
If you have a small printer the body will have to be split into pieces and glued.
Printed and tested and it works very well.
Print the pins in PETG for flexibility. The rake body can be PLA. No support is needed. Push a piece of steel wire through the hole in the body and pins to hold the pins in place. 33 pins are required.
If you have a small printer the body will have to be split into pieces and glued.
Snabel_a veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
