Thingiverse
Wide leaf rake
por Snabel_a
4
Descargas
10
Likes
0
Makes
This is a 60cm wide rake for a 28mm wooden handle.
Printed and tested and it works very well.
Print the pins in PETG for flexibility. The rake body can be PLA. No support is needed. Push a piece of steel wire through the hole in the body and pins to hold the pins in place. 33 pins are required.
If you have a small printer the body will have to be split into pieces and glued.
Printed and tested and it works very well.
Print the pins in PETG for flexibility. The rake body can be PLA. No support is needed. Push a piece of steel wire through the hole in the body and pins to hold the pins in place. 33 pins are required.
If you have a small printer the body will have to be split into pieces and glued.
Snabel_a también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
